Manual Eject Assembly Removal/Installation - Sony Digital Betacam DVW-707 Maintenance Manual

4-1-3. Manual Eject Assembly
Removal/Installation
Removal
(1) Turn the power off.
(2) Remove the front lid and the outside panel.
(Refer to section 1-6 of Maintenance Manual
Part 1.)
(3) Remove the screw and the manual eject as-
sembly.
Installation
(1) Pass the big hole of the manual eject assembly
through the capstan shaft.
(2) Tighten the screw.
(3) While pressing down the knob of the manual
eject assembly, turn it in the direction or re-
verse direction of the arrow. When turning it,
check that the gears correctly engage and turn.
m
. After the cassette compartment raised up, do not
keep on turning the manual eject knob counter-
clockwise.
If keep on turning it, the component parts of the
unit will break.
When the marking on the cam is at position
shown in the figure, never turn the manual eject
knob counterclockwise.
. When closing the front lid after using the manual
eject knob, be sure to turn the power on.
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
4-1. General Information for Parts Replacement and Adjustment
Manual eject assembly
Capstan shaft
Cam
Intermittent
gear
Mark
Cassette
compartment
(unthreading mode)
Screw (PWH 1.4x2.5)
Positioning pin
Manual eject
knob
4-3