Sony Digital Betacam DVW-707 Maintenance Manual page 103

Installation
3. Brush Assembly Installation
(1) Temporarily attach the brush assembly to the
brush support using the screw shown in the
figure.
n
Never touch the brush.
(2) Move the brush base while pressing down the
brush base above the brush support and tempo-
rarily attach the brush assembly using the oth-
er screw.
(3) Tighten the screws which are attached in steps
(1) and (2).
(4) Check that the brush touches against the slip
ring.
n
Once steps (1) to (3) are completed, the height
of the brush and contact pressure against the
slip ring will be automatically adjust.
(5) Connect the connector on the brush assembly
board.
4. Brush Cover Installation
Align the hole of the brush cover with the shaft of
the slip ring and tighten the two screws.
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
Brush
Slip ring
Connector
4-2. Parts Replacement
Brush base
P 2x4
Temporarily
attach this
screw first.
Brush support
Brush Slip ring
4-19