Power Switch, Mic In Connector - Sony Digital Betacam DVW-707 Maintenance Manual

3-3. Replacing the External Connectors/Switches

3-3-3. POWER Switch, MIC IN Connector

POWER Switch
1. Remove the front assembly. (Refer to Section
"3-2-1. Replacing the CCD Unit".)
2. Disconnect the harness from the connector
(CN10) on the MB-810 board.
3. Remove the hexagon nut to remove the
POWER switch.
4. Reattach the POWER switch by reversing the
removing steps.
n
Reinstall the POWER switch as shown in the
figure (viewed from above).
MIC IN Connector
1. Remove the POWER switch.
(Refer to Section 3-3-3.)
2. Disconnect the harness from the connector
(CN300).
3. Remove the two screws to remove the
MA-94 board.
4. Remove soldering from the MIC IN connec-
tor to remove the connector.
5. Reattach the MIC IN connector by reversing
the removing steps.
3-20
POWER switch
Red
Gray
POWER switch
Front panel side
MA-94 board
(MIC IN connector)
P 2.6x5
CN300
MB-810 board
CN10
Hexagon nut
Top view
IF-716 board
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1