Disconnecting/Reconnecting Flexible Card Wires; Ic Link - Sony Digital Betacam DVW-707 Maintenance Manual

1-3. Disconnecting/Reconnecting Flexible Card Wires

1-4. IC Link

1-3. Disconnecting/Reconnecting
Flexible Card Wires
The three flexible card wires are used in the connection of
the MB-810 board and the TC-101 board.
Be careful not to bend forcedly these flexible card wires.
Crease of wire can seriously shorten its life.
n
Turn off the power, and then unplug the power cord or
remove the battery before disconnecting/reconnecting the
wires.
Disconnecting
1. Slide portions A in the direction of the arrow to unlock
the connector, and then pull the flexible card wire out.
Slide portions A
flexible card wire
1-8
Reconnecting
1. Check to see that the conductive surface (silver side)
2. Slide portions A in the direction of the arrow, and then
3. Slide portions A in the reverse direction to lock the
1-4. IC Link
w
The IC link is critical for safe operation.
To avoid danger of a fire or electric shock, be sure use the
specified component as a spare part when replacing it.
c
Replacement of the IC link of the plugged-in unit may be
Flexible card wire
hazardous.
Be sure to turn off the power, and then unplug the cord
from the DC IN connector before replacing the IC link.
An IC link is mounted on the B side of the HP-93 board.
This will blow when the overcurrent flows because of
internal circuit failure. If it blows, check the circuit for
overcurrent after turning off the power.
And then, replace the IC link with specified part.
Board
HP-93
of the flexible card wire is not soiled with dust.
insert the flexible card wire into the connector with the
conductive surface (silver side) down.
n
Be sure to insert the wire straightforward.
connector.
Ref. No. Description
F1 IC Link 2A
Part No.
1-533-282-21
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1