Sony Digital Betacam DVW-707 Maintenance Manual page 144

4-2. Parts Replacement
5. Mechanical Deck Assembly Installation
(1) Check that the bending portion of the HN
holder of the mechanical deck assembly puts
in the square hole of the reinforcement bracket
which attaches to the HN-260 board.
(2) Hold the shaded portion of the arm on the cas-
sette compartment, or cassette guide, and HN-
260 board shown in the figure and align the
two guide holes on the mechanical deck as-
sembly with the two pins of the chassis.
(3) Push down the ornamental bracket of the HN-
260 board and connect the 100-pin connector
to the mother board.
(4) Tighten the four screws of the mechanical
deck assembly.
4-60
Square hole
HN holder
100-pin connector
HN-260 board
Cassette guide
Cassette
compartment
arm
Screws
(with drop-safe)
HN holder
Reinforcement
bracket
HN-260 board
Screws
(with drop-safe)
HN-260 board
Guide hole
Pin of the chassis
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1