Test Saw Adjustment - Sony Digital Betacam DVW-707 Maintenance Manual

8-7. TEST SAW Adjustment

Preparation
. OUTPUT/DCC switch (inside panel)
. WHITE BAL switch (inside panel)
Adjustment Procedure
Equipment : Waveform monitor
Test point : TEST OUT connector
1. On the setup menu, set as follows.
PAGE : S12*FUNCTION 1/2
ITEM : GAMMA
2. AUTO W/B BAL switch (front panel)
(Perform the automatic black balance adjustment.)
3. On the setup menu, adjust as follows.
PAGE : S21*LEVEL 4
ITEM : MASTER BLACK
Spec. : A = 8.0
A = 2.0 1.0 mV (PAL)
4. On the setup menu, set as follows.
PAGE : S53*VA ADJ. 2/2
ITEM : TEST SAW
5. On the setup menu, set as follows.
PAGE : S53*VA ADJ. 2/2
ITEM : TEST OUT
6. On the setup menu, adjust as follows.
PAGE : S52*VA ADJ. 1/2
ITEM : TEST LEVEL
Spec. : B = 100
B = 700 10 mV (PAL)
B
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
CAM/ON
PRST
OFF
BLK
0.2 IRE (NTSC)
A
ON
G
2 IRE (NTSC)
Setting After Adjustment
. On the setup menu, set as follows.
PAGE : S12*FUNCTION 1/2
ITEM : GAMMA
ITEM : TEST SAW
ITEM : TEST OUT
8-7. TEST SAW Adjustment
ON
OFF
ENC
8-9