Sony Digital Betacam DVW-707 Maintenance Manual page 216

5-1. Tape Running Adjustment
Adjustments
8. S2, Tension Regulator and S5 Guides
Height Adjustment
(1) Enter the PLAY mode at the tape top of ZR2-
1/P (from 5 minute to 10 minute segment).
(2) Loosen the set screws at the top of the guides
using the tape guide adjustment screwdriver.
Turn the upper flanges of the guides, and
adjust the heights of the guides so that satisfy
the specifications 1 to 3.
(3) Tighten the screws at the top of the guides.
9. Tape Running Re-check at the Drum
Entrance Side
Perform from the steps 1 to 7 of the check
procedures, and re-check that the specifications
are satisfied.
If the specifications are not satisfied, perform step
8 again.
10. Tape Running Check at the Drum Exit
Side.
Check the tape running at the drum exit side on
the following page and later.
Checks After Adjustment
11. Video Tracking Check
Refer to section 5-2.
12. CTL Head Height Check
Refer to section 5-3.
13. CTL Head Position Check
Refer to section 5-4.
14. CUE/TC Head Position Check
Refer to section 5-8.
5-6
Tape guide adjustmnet
screwdriver
Set screw
Upper flange
Tape guide
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1