Sony Digital Betacam DVW-707 Maintenance Manual page 68

3-2. Replacing the CCD Unit and Its Components
8. Reinstalling the Front Assembly
(1) Ensure that the harnesses removed in step 1 is
reconnected to the VA-191 board (CN2) and
the BC-31/32 board (CN1).
(2) Reinstall the front assembly using the four
screws.
Standard tightening torque :
80 x 10
n
Reinstalling the front assembly will mate the
CN20 of the SW-971 board in the CN200 of
the IF-716 board.
Ensure that these connectors are engaged
securely without pressing in forcedly.
(3) Close the inside panel, and then reattach the
outside panel.
Adjustment After Replacement
9. Tape Running Adjustment
(Refer to Section 5-1.)
10. Electrical Alignment
. Camera System Electrical Alignment
*1 *2
(Refer to Section 4 or 5
Manual Part 1.)
. VCO CONT Frequency Check
*1
(Refer to Section 7-2 or 8-2
. AD Clock Phase Adjustment
*1
(Refer to Section 7-3 or 8-3
*1: For DVW-709WS/709WSP/790WS/790WSP only
*2: For DVW-707/707P only
3-12
_2
N.m {8 kgf.cm}
in the Maintenance
*2
.)
*2
.)
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1