Knee And White Clip Adjustments; Manual Knee And White Clip Adjustments - Sony Digital Betacam DVW-707 Maintenance Manual

7-15. Knee and White Clip Adjustments

7-15. Knee and White Clip Adjustments
7-15-1. Manual Knee and White Clip
Adjustments
Preparation
. OUTPUT/DCC switch (inside panel)
. WHITE BAL switch (inside panel)
. GAIN switch (inside panel)
. On the setup menu, set as follows.
PAGE : S12*FUNCTION 1/2
ITEM : TEST SAW
PAGE : S21*LEVEL 4
ITEM : WHITE CLIP
ITEM : KNEE
Adjustment Procedure
Equipment : Waveform monitor
Test point : TEST OUT connector
1. On the setup menu, set as follows.
PAGE : S21*LEVEL 4
ITEM : KNEE SLOPE
2. On the setup menu, adjust as follows.
PAGE : S21*LEVEL 4
ITEM : KNEE POINT
Spec. : A = 98 ±2 IRE (NTSC)
A = 686 ±10 mV (PAL)
A
3. GAIN switch (inside panel)
4. On the setup menu, set as follows.
PAGE : S21*LEVEL 4
ITEM : WHITE CLIP
ITEM : KNEE SLOPE
7-20
CAM/OFF
PRST
M (9 dB)
ON
OFF
OFF
_99
H (18 dB)
ON
99
5. On the setup menu, adjust as follows.
PAGE : S21*LEVEL 4
ITEM : WHITE CLIP LEVEL
: B = 109 ±2 IRE (NTSC)
Spec.
B = 763 ±10 mV (PAL)
6. GAIN switch (inside panel)
7. On the setup menu, set as follows.
PAGE : S21*LEVEL 4
ITEM : WHITE CLIP
8. On the setup menu, adjust as follows.
PAGE : S21*LEVEL 4
ITEM : KNEE SLOPE
: C = 109 ±2 IRE (NTSC)
Spec.
C = 763 ±10 mV (PAL)
Setting After Adjustment
. GAIN switch (inside panel)
. On the setup menu, set as follows.
PAGE : S12*FUNCTION 1/2
ITEM : TEST SAW
PAGE : S21*LEVEL 4
ITEM : WHITE CLIP
ITEM : KNEE
n
The values used in the above adjustment are for the
conditions that the white clip level is set to 109 IRE
(763 mV). When the white clip level is set to a value other
than 109 IRE (763 mV), use the following table to set the
levels of the knee point and knee slope.
WHITE CLIP LEVEL (Unit : IRE/mV)
109/763
KNEE POINT 98/686
KNEE SLOPE 109/763
WHITE CLIP 109/763
B
M (9 dB)
OFF
C
L (0 dB)
OFF
ON
ON
107/749 105/735 103/721
96/686 96/672 96/672
107/750 107/750 107/750
107/750 105/735 103/721
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1