Sony Digital Betacam DVW-707 Maintenance Manual page 153

Installation
5. CUE Head Replacement
(1) Disconnect the connector CN2 on the CUE-2
board.
(2) Remove the screw and open the CUE-2 board.
(3) Remove the two screws at the top of the CUE
head block and the CUE head.
In this way the shield case and the adjustment
plate (R) are removed.
(4) Desolder the four leads from the printed circuit
board of the CUE head, and re-solder them to
the new CUE head.
n
Never mistake the soldering positions.
(5) After putting the new CUE head in the shield
case, assemble the parts in the sequence shown
in the figure and tighten the two screws.
(6) Attach the CUE-2 board using the two screws.
(7) Connect the harness connector from the CUE
head to the connector CN2 on the CUE-2
board.
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
PWH 1.4x2.5
CN2
Lead wire (red)
Lead wire (gray)
CUE head
Lead wire (red)
Lead wire (gray)
3P connector (to CN12)
4-2. Parts Replacement
CUE-2 board
PSW 2x5
CUE head
Adjustment
plate (R)
Shield case
2P
connector
(to CN2)
4-69