Sony Digital Betacam DVW-707 Maintenance Manual page 190

4-2. Parts Replacement
7. Motor Installation
Attach the motor unsig the two screws.
The standard tightening torque value :
21 x 10
8. Gear Block Assembly Installation
(1) While connecting the connector of the tape top
sensor theat connects to the rear block assem-
bly to the connector on the SE-275 board
which is attached to the chassis, put the pin of
the chassis in the longitudinal hole of the gear
block assembly and the top of the joint gear
that is attached to the chassis in the round hole
of the gear block assembly. Tighten the three
screws.
The standard tightening torque value :
9 x 10
(2) Connect the harness connector to the connec-
tor CN3 on the CUE-2 board.
9. Cassette Compartment Installation
Attach the cassette compartment using the three
screws. (Refer to section 1-8 of Maintenance Man-
ual Part 1.)
The standard tightening torque value :
9 x 10
4-106
_2
N.m {2.1 kgf.cm}
_2
N.m {0.9 kgf.cm}
_2
N.m {0.9 kgf.cm}
Round hole
Connector
(Tape top sensor)
Connector (SE-210 board)
PWH 1.4x2.5
Longitudinal hole
CUE-2 board
CN3
Pin (chassis)
Joint gear
DVW-790WS/709WS/707 P2V1
DVW-790WSP/709WSP/707P P2V1