Test Out Level Adjustment; Modulator Balance Adjustment - Sony Digital Betacam DVW-707 Maintenance Manual

8-5. TEST OUT Level Adjustment

8-6. Modulator Balance Adjustment

8-5. TEST OUT Level Adjustment
Preparation
. OUTPUT/DCC switch (inside panel)
. On the setup menu, set as follows.
PAGE : S23*LEVEL 6
ITEM : TEST OUT
Adjustment Procedure
Equipment : Waveform monitor
Test point : TEST OUT connector
1. On the setup menu, adjust as follows.
PAGE : S23*LEVEL 6
ITEM : RGB SYNC
Spec. : A = 40
A = 300 14 mV (PAL)
2. On the setup menu, adjust as follows.
PAGE : S23*LEVEL 6
ITEM : RGB SETUP
Spec. : B = 7.5
B = 0
3. On the setup menu, adjust as follows.
PAGE : S23*LEVEL 6
ITEM : RGB LEVEL
Spec. : C = 100
C = 700 14 mV (PAL)
NTSC
R
C
A
Setting After Adjustment
. On the setup menu, set as follows.
PAGE : S23*LEVEL 6
ITEM : TEST OUT
8-8
BARS
R, G or B
2 IRE (NTSC)
0.5 IRE (NTSC)
3 mV (PAL)
2 IRE (NTSC)
PAL
R
C
B
A
ENC
8-6. Modulator Balance Adjustment
Preparation
. WHITE BAL switch (inside panel)
. OUTPUT/DCC switch (inside panel)
. MENU ON/OFF/PAGE switch (inside panel)
Adjustment Procedure
1. AUTO W/B BAL switch (front panel)
Hold this switch in BLK state untilthe message
"_MOD BAL_" on the viewfinder is displayed .
2. A few seconds later after releasing the switch, check
that the message "BLACK OK" is displayed on the
viewfinder.
B
PRST
CAM/ON
OFF
BLK
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1