Dog Type Rear End Reference Home Position Return - Mitsubishi Electric MR-J2S-CP Instruction Manual

4. OPERATION

4.4.7 Dog type rear end reference home position return

The position where the axis, which had started decelerating at the front end of a proximity dog, has
moved the after-proximity dog moving distance and home position shift distance after it passed the rear
end is defined as a home position. A home position return that does not depend on the Z-phase signal can
be made.
(1) Signals, parameters
Set the input signals and parameters as indicated below.
Item
Manual home position return mode
selection
Dog type rear end reference home
position return
Home position return direction
Dog input polarity
Home position return speed
Creep speed
Home position shift distance
Moving distance after proximity dog
Home position return acceleration/
deceleration time constants
Home position return position data
(2) Timing chart
Automatic/manual
selection (MD0)
Movement finish (MEND)
Rough match (CPO)
Home position return
completion (ZP)
Servo motor speed
Proximity dog (DOG)
Forward rotation start (ST1)
Reverse rotation start (ST2)
The parameter No.42 (home position return position data) setting value is the positioning address
after the home position return is completed.
POINT
This home position return method depends on the timing of reading
Proximity dog (DOG) that has detected the rear end of a proximity dog.
Hence, if a home position return is made at the creep speed of 100r/min, an
error of 200 pulses will occur in the home position. The error of the home
position is larger as the creep speed is higher.
Device/Parameter used
Automatic/manual selection (MD0) Short (turn on) MD0-SG.
Point table No. selection 1 (DI0)
Point table No. selection 2 (DI1)
Parameter No.8
Parameter No.8
Parameter No.8
Parameter No.9
Parameter No.10
Parameter No.11
Parameter No.43
Point table No.1
Parameter No.42
ON
OFF
ON
OFF
ON
OFF
ON
OFF
Home position return speed
3ms or less
ON
OFF
ON
OFF
5ms or more
ON
OFF
Open (turn off) DI0-SG.
Open (turn off) DI1-SG.
5: Select the dog type rear end reference.
Refer to section 4.4.1 (2) and select the home position return direction.
Refer to section 4.4.1 (2) and select the dog input polarity.
Set the speed till the dog is detected.
Set the speed after the dog is detected.
Set when the home position is moved from where the axis has passed
the proximity dog rear end.
Set the moving distance after the axis has passed the proximity dog
rear end.
Use the acceleration/deceleration time constant of point table No. 1.
Use to set the current position on completion of home position return.
Moving distance after proximity dog
Home position shift distance
Creep speed
Proximity dog
4 - 35
Description
Home position address
Parameter No. 42