Mitsubishi Electric MR-J2S-CP Instruction Manual page 150

5. PARAMETERS
Class No. Symbol
46 *LMP Software limit
47 Used to set the address increment side software stroke limit. The software limit
is made invalid if this value is the same as in "software limit
(Refer to section 5.2.8)
Set the same sign to parameters No.46 and 47. Setting of different signs will
result in a parameter error.
*LMN Software limit
48
Used to set the address decrement side software stroke limit. The software limit
49
is made invalid if this value is the same as in "software limit ".
(Refer to section 5.2.8)
Set the same sign to parameters No.48 and 49. Setting of different signs will
result in a parameter error.
Position range output address
50 *LPP
Used to set the address increment side position range output address. Set the
51
same sign to parameters No.50 and 51. Setting of different signs will result in a
parameter error.
In parameters No. 50 to 53, set the range where position range (POT) turns on.
Position range output address
52 *LNP
Used to set the address decrement side position range output address. Set the
53
same sign to parameters No.52 and 53. Setting of different signs will result in a
parameter error.
Name and Function
Set address:
Lower 3
Upper 3
digits
digits
Set address:
Lower 3
Upper 3
digits
digits
Set address:
Upper 3
Lower 3
digits
digits
Set address:
Upper 3 Lower 3
digits digits
5 - 13
".
Parameter No. 47
Parameter No. 46
Parameter No. 49
Parameter No. 48
Parameter No. 51
Parameter No. 50
Parameter No. 53
Parameter No. 52
Initial Setting
Unit
value range
0 10 999999
STM
m
to
999999
0 10 999999
STM
m
to
999999
0 10 999999
STM
m to
999999
0 10 999999
STM
m
to
999999