EPSON EPL-N1600
4.3.18 Roll Assembly Pinch Pre-Registration
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Pull the Lever Jam Clear off of the retaining brackets (1).
7. Remove the Spring-Hold Rod, Stopper Rod, and Spring Nip Pre-
Registration (2).
8. Remove the Frame Assembly MBF.(Section 4.3.19)
9. Remove the C258MAIN Board.(Section 4.3.49)
10. Remove the Shield Assembly Bottom (E).(Section 4.3.44)
11. Remove the PWBA Hotaru.(Section 4.3.48)
12. Remove the Actuator No Paper.(Section 4.3.8)
13. Remove the Drive Assembly-F/P.(Section 4.3.42)
14. Remove the Drive Assembly Main.(Section 4.3.43)
15. Remove the Sensor Toner if installed.
16. Remove the Kit Chute Registration Assembly. (Section 4.3.11)
17. Squeeze together the latches of the Roll Assembly Pinch Pre-
registration (3) and take it out of the Frame (4).
Rev. A
Chapter 4
Figure 4-24. "Roll Assembly Pinch Pre-Registration" Removal
Disassembly and Assembly
4-127