Thermostat And Fuse - Epson EPL-N1600 Service Manual

EPSON EPL-N1600

4.3.33 Thermostat and Fuse

1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the Roll Assembly Exit Out. (Section 4.3.27)
7. Remove the Fuser Assembly. (Section 4.3.31)
8. Remove Roll Assembly Exit.(Section 4.3.34)
9. Remove the Roll Fuser and Heater Quartz from the Fuser
Assembly.(Section 4.3.36)

Do not touch the surface of the Roll Fuser. Hold the
ends of the Roll Fuser when handling the Roll Fuser.

Do not touch the Heater Quartz with your fingers.
Hold the Heater by the metal tabs that are attached to
the ends of the Heater when handling the Heater
Quartz.
10. Remove the two screws that secure the Thermostat to the Fuser
Frame and remove the Thermostat.
11. Remove the one screw that retains one end of the Fuse to the Fuser
Frame.
12. Remove the short strip conductor over the left leg of the Fuse, and
remove the Fuse.
Rev. A
Chapter 4 Disassembly and Assembly
Figure 4-39. "Thermostat/Fuse" Removal
4-142