Cover Assembly Exit,E - Epson EPL-N1600 Service Manual

EPSON EPL-N1600

4.3.1 Cover Assembly Exit,E

1. Remove the Cover Side, E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E. (Section 4.2.4)
4. Remove the Tray Assembly MBF.E. (Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Set the Cover Assembly,E on its rear surface.
7. Remove the three screws that secure the Bracket Hinge,E to the
Cover Assembly,E.
8. Carefully manipulate the Cover Exit,E to move the Bracket Hinge
away from the mount toward you and then raise the right side of the
Cover Exit to tilt the Cover Exit (1).
Be careful not to damage the strip conductor laid by
the Bracket Hinge.
9. Shift the Cover Exit to the right to get the pivot on the left arm out of
the pivot hole on the left side of the Cover Main (2).
10. Take the Cover Exit out of the Cover Assembly,E (3).
Rev. A
Chapter 4 Disassembly and Assembly
Figure 4-7. "Cover Assembly Exit,E" Removal
4-110