Frame Assembly Mbf - Epson EPL-N1600 Service Manual

EPSON EPL-N1600

4.3.19 Frame Assembly MBF

1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the Lever Jam Clear, Spring-Hold Rod, Stopper Rod, and
Spring Nip Pre-Registration (steps 6 and 7 of RRP 4.1.1).
7. Disconnect P236-1/J236-2 and P234-2/J2342.
8. Remove the four screws that secure the Frame Assembly MBF to
the Printer Frame.
9. Slowly take the Frame Assembly MBF off of the Frame,
manipulating so that the free end of the shaft of the Roll Assembly
MBF comes out of the receptacle.
Rev. A
Chapter 4 Disassembly and Assembly
Figure 4-25. "Frame Assembly MBF" Removal
4-128