Epson EPL-N1600 Service Manual page 61

EPSON EPL-N1600
LED Description
Jam in Duplex Cover
Online: OFF A paper jam has occured in a
rear cover of the Duplex unit.
Continue: OFF
Insert Imaging Crtg
Online: OFF The imaging cartridge is not
installed in the printer.
Continue: OFF
Printer Open
Online: OFF The top cover is open.
Continue: OFF
Duplex Cover Open
Online: OFF A rear cover of the Duplex Unit
is open.
Continue: OFF
Insert Duplex Tray
Online: OFF The tray is not set inside the
Duplex Unit.
Continue: OFF
Manual Feed xxx yyyy
Online: OFF If "Manual Feed=On" has been
selected, this error occurs when
Continue: Blink
the printer receives the print
job.
xxx: Paper supply source
yyyy: Paper size
Insert LC1
Online: OFF Standard cassette is not set in
the printer.
Continue: OFF
Rev. A
Action
Open the Duplex Unit and
remove any jammed paper. The
error state will be concelled
automatically by closing the
Duplex Unit. The printer resume
printing from the first face after
warm-up.
Open the top cover and install
the imaging cartridge.
Close the top cover.
Close the cover.
Reinstall the tray.
Do one of the following:
• Set the paper in specified
paper supply and press either
Online or Continue button. The
printer prints with the specified
paper supply and indicates the
same error again at next page
printing.
• Press either Online or
Continue button. The printer
feeds a paper from the paper
supply with highest priority.
• Perform Reset or Warm-boot.
Reinstall the paper cassette.
LED Description
Paper Out sssss tttt
Online: OFF This error occurs when:
Continue: OFF • no paper is available in the
selected paper supply.
• no paper is available in all
connected paper suppy
units. If the error occurs with
this condition, the message
will display "LC1" as sssss.
Paper Set sssss tttt
Online: OFF In case if 'Size Ignore=Off" has
been selected in Config. Menu,
Continue: Blink
this error occur when the paper
size in the selected paper
supply and the paper size
specified for printing is different.
Chapter 3 Troubleshooting
Action
Set specified size of paper in the
seletced paper supply.
1. If "Auto Cont=OFF":
The error can be cancelled by
either:
• Press Continue button after
putting a specified size of
paper in the selected paper
supply
• Press Continue button without
changing the paper in the
selected paper supply.
2. If "Auto Cont=ON":
In this case, the error is cancelled
automatically after passing the
specified period of time, and the
printer resume printing by
feeding a paper from the selected
paper supply.
63