Sensor Assembly-Size 1,E - Epson EPL-N1600 Service Manual

EPSON EPL-N1600

4.3.2 Sensor Assembly-Size 1,E

1. Remove the Cover Side, E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E. (Section 4.2.4)
4. Remove the Tray Assembly MBF.E. (Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the C258MAIN Board. (Section 4.3.49)
7. Remove the Shield Assembly Bottom (E). (Section 4.3.44)
8. Set the printer on its rear side.
9. Remove the PWBA Hotaru.
10. Disconnect P/J236-1 (Harness Assembly MBF) and P/J234-2
(Harness Solenoid) located at the left side of the ROS Assembly,
and route the Harness Assembly MBF and the Harness Solenoid
out of the Frame (1).
11. Push the Sensor Assembly-Size 1,E downward while pressing the
latching tab in the rectangular hole located near the J24 harness by
a small screwdriver blade (2).
The latch tab is in contact with the rear side wall (lower
side wall when the printer is set on the rear side) of the
access hole. Press the latch tab until it disengages
from the side wall of the rectangular hole.
12. Take the Sensor Assembly-Size 1,E out of the Printer Frame.
13. Disconnect P234 and P236 from the Sensor Assembly Size-1,E.
Rev. A
Chapter 4
Figure 4-8. "Sensor Assembly Size 1,E" Removal
Disassembly and Assembly
4-111