Epson EPL-N1600 Service Manual page 100

EPSON EPL-N1600
Item Button(s)
Force-erase the • Alt Erase all data in the Flash-ROM module installed in slot-
Flash-ROM module A. The erase operation starts when the LCD message is
• Item
changed to "Erase DIMM A". After completing erase
• Value
operation, the printer performs warm-boot and returns to
• Enter
normal state.
Update Program • Online Update the contents of ROM module installed in the
ROM program ROM slot.
• Alt
1. Connect the PC to the printer with a parallel I/F.
• Value
2. Enter the mode.
3. The LCD panel displays a message "Program
4. The LCD panel message is changed to "Please Send
5. Transfer the new program ROM data file from the PC
6. Press Enter button to continue the update operation,
7. When Enter button is pressed, a message "Erasing
8. After completing the data erase, the printer is writing
9. When completing the data write, a check-sum value
10.Press Enter button and a message "O.K:Please
Rev. A
Description
Device.." for 3 seconds and changed to a message
"Version 00.02 .." for another 3 seconds.
Data" and wait for the data transfer from the
connected PC.
If you turn off the printer at this point, the update
operation is cancelled and the contents of program
ROM module remains unchanged.
to the printer in BINARY transfer mode. The LCD
panel message is changed to "OLD:xxxxx
NEW:xxxx" and goes to stand-by state.
or pressing MENU button to display a message
"WAIT RESET" and discard received data (the
contents of program ROM module remains
unchanged).
Device" is displayed and all the contents of ROM
module are being erased. Once this message is
displayed, the contents of ROM module cannot be
recovered.
the received data to the ROM module, and while
writing the data, a message "PRG xxxxxxxx" is
displayed on the LCD panel.
is displayed on the LCD panel as "xxxx, xxxx, xxxx,
xxxx".
Reboot" appear on the LCD. Press Enter button
again to start rebooting the printer and the printer
become ready state.
Chapter 4
Item Button(s)
Copy ROM Module • Online Copy the contents of ROM module installed in slot-B to a
Flash-ROM module installed in slot-A. If slot-B is vacant,
• ALT
the contents of ROM module in program socket are
• Enter
copied instead.
1. Enter the mode.
2. When a message "DIMM COPY MODE" is displayed,
3. When data copy complete, the printer perform warm-
Toner Counter • Online Reset the toner counter value to "E
Reset
• Form Feed
Maintenance Mode • Online A menu item "Maintenance Menu" will be added as a
menu item.
• Form Feed
With the EPL-N1600, an item "Reset Roller" will be
• Continue
added and this function is used to initialize the position
of pick up roller in the MP Tray and the paper cassette in
order to prevent possible paper jam at the power on.
Disassembly and Assembly
Description
press Enter button to continue and a data copy starts
after erasing the contents of target ROM module.
boot sequence and returns to normal state.
F".
4-102