Error Messages - Epson EPL-N1600 Service Manual

EPSON EPL-N1600

3.1.2.2 Error Messages

The table below lists the error messages and an operation to be
performed. When any error state is detected by the printer, the Online
LED goes off and the Conitnue LED indicates the following three
conditions.
Continue LED = OFF: If the error condition can be removed, the printer
restarts automatically without pressing the
Continue button.
Continue LED = Blink: The printer restarts when the Continue button is
pressed. If "Auto-Cont" is ON in the device
menu, the error status is cancelled automatically
after the specified period of time has passed.
Continue LED = ON: The printer restart only when the Continue
button is pressed after removing the error.
Table 3-4. Printer Message - Error
LED Description
Duplex Unit Fail
Online: OFF The duplex unit becomes
unvalid during power on.
Continue: OFF
Check Duplex P-Size
Online: OFF Occurs only during duplex
printing, if "Size Ignore=Off" has
Continue: Blink
been selected in Device menu.
The paper loaded is shorter
than the paper size specified for
printing.
If the error occur at first face
printing, the printer eject the
sheet without printing next face.
Rev. A
Action
Turn the printer off and re-install
the duplex unit.
Set correct paper in the printer
and press Continue button. Then
restart printing.
LED Description
Exiting Paper Jam
Onlin:OFF A paper jam has occured at the
Fusing process.
Continue:OFF
Paper Jam
Online: OFF A paper jjam has occured at the
image transfer process.
Continue: OFF
Feed Jam
Online: OFF A paper jam has occured at the
paper entrance.
Continue: OFF
If another paper jjam has
occured at thhe same time, the
error message displayed on the
LCD will be the one
corresponding to another paper
jam, such as "Paper Jam".
Paper Jam in Duplex
Online: OFF A paper jam hhas occured in
the Duplex Unit.
Continue: OFF
Jam in Duplex Tray
Online: OFF A paper jam has occured in the
Duplex Tray.
Continue: OFF
Chapter 3 Troubleshooting
Action
Open the top cover and remove
the imaging cartridge. Then
remove jammed paper inside the
printer.
The error state will be cancelled
automatically by closing the top
cover and the printer resume the
printing after warm-up.
Open the top cover and remove
jammed paper.
The error state will be cancelled
automatically by closing the top
cover and the printer resume the
printing after warm-up
Open the top cover and check for
any jammed paper at the paper
entrance.
The error state will be cancelled
only when the top cover is
closed. The printer wil resume
printing after warm-up.
Open the Duplex Unit and
remove any jammed paper.
The error state will be concelled
automatically by closing the
Duplex Unit.
Take out the Duplex Tray and
remove jammed paper. The error
state will be cancelled by
reinstalling the Duplex Tray.
The printer resume printing from
first face after warm-up.
62