EPSON EPL-N1600
4.3.15 Actuator Exit-2/L, -2/S and Sensor Photo
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the three screws that secure the Plate Base Actuator, and
remove the Plate Base Actuator, taking care to keep the Actuator
Exit-2/L and -2/S mounted on the Plate in place.
7. Note how the Spring Exit- 2/L and -2/S are attached to the
Actuators.
8. Lift the Actuator Exit-2/L, along with the Spring Exit-2/L, out of the
Plate.
9. Lift the Actuator Exit-2/S, along with the Spring Exit-2/S, out of the
Plate.
10. Press together the hooks of the Sensor Photo while pushing the
Sensor out through the Frame.
11. Disconnect J285 from the Sensor Photo.
Rev. A
Chapter 4
Figure 4-21. "Actuator Exit-2/L,2/S and Sensor Photo" Removal
Disassembly and Assembly
4-124