EPSON EPL-N1600
4.3.12 Actuator Registration
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the Lever Jam Clear, Spring-Hold Rod, Stopper Rod, and
Spring Nip Pre-Registration (steps 6 and 7 of RRP 4.1.1).
7. Remove the Frame Assembly MBF.(Section 4.3.19)
8. Remove C258MAIN Board.(Section 4.3.49)
9. Remove Shield Assembly Bottom (E).(Section 4.3.44)
10. Remove PWBA Hotaru.(Section 4.3.48)
11. Remove the Chassis Assembly PS.(Section 4.3.46)
12. Remove the Roll Assembly Feed.(Section 4.3.7)
13. Remove the Actuator No Paper.(Section 4.3.8)
14. Remove the Drive Assembly-F/P.(Section 4.3.42)
15. Remove the Drive Assembly Main.(Section 4.3.43)
16. Remove the Drive Assembly.(Section 4.3.3)
17. Remove the Sensor Tone if installed.
18. Remove the Kit Chute Registration Assembly. (Section 4.3.11)
Rev. A
Chapter 4
19. Pull the Actuator Registration, along with the Spring Sensor
Registration, out of the retaining holes in the mounting posts on the
Printer Frame.
Figure 4-18. "Actuator Registration" Removal
Disassembly and Assembly
4-121