Oki CX4545 MFP Manual page 202

8 [Administration] Tab Page
 Setting up Default Raw Job Setting
In Default Raw Job Setting, you can specify the default raw job setting, which applies to a raw job for which no queue
name is specified or for which a specified queue name does not exist.
You can also add LPR queue names and specify the raw job setting for each queue.
 P.201 "Setting up Raw Job Setting"
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Item name
1 Raw Jobs - Duplex Printing
2 Raw Jobs - Default Paper Size
3 Raw Jobs - Default Paper Type
4 Raw Jobs - Default Orientation
5 Raw Jobs - Default Stapling
6 Raw Jobs - Default Output Tray
7 PCL Form Line
8 PCL Font Pitch
9 PCL Font Point Size
10 PCL Font Number
11 PCL Line Termination
12 Symbol set
13 Paper Source
14 Do not Print Blank Pages
When printing is performed using the UNIX filters or CUPS, this setting is not reflected. If you do not want to print blank pages
in these printings, enable [Do not Print Blank Pages] in the UNIX filter command or CUPS setting. For the setting instructions,
refer to the Software Installation Guide or Printing Guide.
15 Letterhead Print Mode
200 [Setup] Item list
Select whether a raw job will be printed on both sides of the paper.
Select the default paper size that applies to a raw job.
Select the default paper type that applies to a raw job.
Select the default orientation that applies to a raw job.
Select whether a raw job will be stapled.
Select the default output tray that applies to a raw job. A banner page that is created by
NetWare, UNIX, and Windows operating systems also will be outputted to the tray set here.
Enter the number of lines printed per page.
Enter the font pitch when the selected font number represents a fixed pitch scalable font.
The font pitch indicates the number of ANK characters per inch. 10 pitch prints 10 ANK
characters within an inch.
Enter the font size when the selected font number represents a proportionally spaced
scalable font. The Font Size option allows you to determine the point size (height) of the
default font.
Enter the font number of the internal PCL font to be used as the default font for printing. You
can check the font numbers and internal PCL fonts in the Internal PCL Font List. Refer to the
Printing Guide for the font number and internal PCL fonts.
Select the type of the line termination.
Select the symbol set that applies to a raw job.
Select the paper source that applies to a raw job.
Select whether blank pages are printed or not.
Select whether the last page (odd page number) is printed on the same side as the other
odd-number pages when printing both sides of a Raw print job whose total page number is
odd. Select [ON] to print the last page on the same side (back) as the other odd-number
pages. Select [OFF] to print it on the same side (front) as even-number pages.
Description