Oki CX4545 MFP Manual page 167

8.[Administration] Tab Page
Item name
5 Create SNMP V3 User Information
6 Enable SNMP V3 Trap
7 SNMP V3 Trap User Name
8 SNMP V3 Trap Authentication
Protocol
9 SNMP V3 Trap Authentication
Password
10 SNMP V3 Trap Privacy Protocol
11 SNMP V3 Trap Privacy Password
12 Enable Authentication Trap
13 Enable Alerts Trap
14 IP Trap Address 1 to 10
15 IP Trap Community
16 IPX Trap Address
When you want to use a user name registered in the SNMP V3 User Information list as an SNMP V3 Trap User Name, you
must enter the same protocols and passwords registered for the authentication protocol, authentication password (not
displayed on the list), privacy protocol and password (not displayed on the list) into the fields such as [SNMP V3 Trap
Authentication Protocol], [SNMP V3 Trap Authentication Password], [SNMP V3 Trap Privacy Protocol] and [SNMP V3 Trap
Privacy Password].
If they do not match, information registered in the list will be adopted.
SNMP V3 user information registered into this equipment is displayed in a list. SNMP V3
user information can be registered, edited, deleted or exported. For the details, see the
following:
 P.218 "Registering or editing SNMP V3 user information"
 P.220 "Exporting SNMP V3 user information"
 P.222 "Deleting SNMP V3 user information"
Select whether SNMP V3 Trap is sent or not. [Disable] is set as the default.
Enter an SNMP V3 Trap User Name. You can enter up to 31 alphanumerical characters and
symbols.
Select an authentication protocol.
 HMAC-MD5 — Select this to use HMAC-MD5.
 HMAC-SHA — Select this to use HMAC-SHA.
Enter an authentication password. You can enter up to 31 alphanumerical characters and
symbols.
Select a protocol for data encryption.
 None — Select this not to encrypt data.
 CBC-DES — Select this to use CBC-DES.
 CFB-AES-128 — Select this to use AES-128 (CFB mode).
Enter a privacy password. You can enter up to 31 alphanumerical characters and symbols.
Select whether to send SNMP Traps when this equipment is accessed using SNMP V1/V2
from a different read community. [Enable] is set as the default.
Select whether to send SNMP V1/V2 Traps when an alert condition occurs. [Enable] is set
as the default.
Enter the IP address where the SNMP Traps will be sent. You can specify up to 10
addresses. Specify within the range from 0 0 0 0 to 255 255 255 255.
Enter the trap community name for the IP Traps. You can enter up to 31 alphanumerical
characters and symbols. "public" is set as the default.
Enter the IPX address where the SNMP Traps will be sent. You can enter up to 20
alphanumerical characters and symbols.
8 [Administration] Tab Page
Description
[Setup] Item list 165