Oki CX4545 MFP Manual page 168

8 [Administration] Tab Page
[Create SNMP V3 User Information] screen
You can display this screen by clicking the [New] button in the Create SNMP V3 User Information page.
1
2
3
4
5
6
7
Clicking [Save] on the [Create SNMP V3 User Information] screen instantly registers the SNMP V3 user information,
enabling the registered user to access this equipment via SNMP over a network.
Item name
1 Context Name
2 User Name
3 Authentication Protocol
4 Authentication Password
5 Privacy Protocol
6 Privacy Password
7 Permissions Level
166 [Setup] Item list
Displays the context name.
Enter the user name. You can enter up to 31 alphanumerical characters and symbols.
Select an authentication protocol.
 HMAC-MD5 — Select this to use HMAC-MD5.
 HMAC-SHA — Select this to use HMAC-SHA.
Enter the password when the Authentication option is enabled. You can enter up to 31
characters.
Select a protocol for data encryption.
 None — Select this not to encrypt data.
 CBC-DES — Select this to use CBC-DES.
 CFB-AES-128 — Select this to use AES-128 (CFB mode).
Enter the password for the user information. You can enter up to 31 alphanumerical
characters and symbols.
Select the access permission level of the SNMP V3 user.
 General User — Select this to permit only the reading of data.
 Administrator — Select this to permit both the reading and writing of data.
Description