Oki CX4545 MFP Manual page 166

8 [Administration] Tab Page
 Setting up SNMP Network Service
In SNMP Network Service, you can enable or disable the SNMP to monitor the device status using a network monitoring
utility. If an administrator wants to monitor the device status with a monitoring utility, programmed to match the MIB, you
must enable the SNMP and SNMP Traps.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Item name
1 Enable SNMP V1/V2
2 Read Community
 It is recommended to change the default Read Community name for security reasons.
 If changing the Read Community name, match the setting with the applications in use. Otherwise, applications that use
MIB (TopAccess, TWAIN driver, File Downloader, and AddressBook Viewer) will become unavailable. The SNMP
communication of the printer driver also will be unavailable, so that obtaining the configurations, confirming the
department code, and obtaining the available boxes in e-Filing will be disabled.
 When you leave the [Read Write Community] option blank, the SNMP communication between the SNMP Browser of the
Client computer and this equipment will be disabled.
3 Read Write Community
 It is recommended to change the default Read Write Community name for security reasons.
 If changing the Read Write Community name, match the setting with the applications in use. Otherwise, applications that
use MIB (TopAccess, TWAIN driver, File Downloader, and AddressBook Viewer) will become unavailable. The SNMP
communication of the printer driver also will be unavailable, so that obtaining the configurations, confirming the
department code, and obtaining the available boxes in e-Filing will be disabled.
4 Enable SNMP V3
164 [Setup] Item list
Select whether SNMP V1/V2 monitoring with MIB is enabled or disabled. This must be
enabled to allow users to connect using Local Discovery, TWAIN driver, File Downloader, or
the Address Book Viewer. [Enable] is set as the default.
Enter the SNMP read community name for the SNMP access. You can enter up to 31
alphanumerical characters and symbols other than =, ; (semicolon), #, and \ (backslash).
"public" is set as the default.
Enter the SNMP Read Write community name for the SNMP access. You can enter up to 31
alphanumerical characters and symbols other than =, ; (semicolon), #, and \ (backslash).
"private" is set as the default.
Select whether SNMP V3 monitoring with MIB is enabled or disabled. This must be enabled
to allow users to connect using Local Discovery, TWAIN driver, File Downloader and the
AddressBook Viewer.
Description