Oki CX4545 MFP Manual page 173

8.[Administration] Tab Page
Item name
8 Policy
[Add Filter] / [Modify Filter] screen
You can display this screen by clicking the [Add] button for Filter or a registered filter name.
You can create a filter to use in IPsec.
1
2
3
4
5
6
7
8
9
10
11
1
2
3
4
5
6
7
8
9
10
11
Item name
1 [OK] button
2 [Cancel] button
3 [Reset] button
4 Filter Name
5 Internet Protocol Version
6 Source Address
7 Destination Address
Create a policy to use in IPsec by combining the registered profiles.
[Add] button — You can add a policy on the [Add Policy] screen.
 P.179 "[Add Policy] / [Modify Policy] screen"
[Delete] button — Select policies to delete and click the [Delete] button to delete them.
Policy Name — Click a registered policy name to modify its content.
 P.179 "[Add Policy] / [Modify Policy] screen"
Saves the folder setting.
Cancels registration of the folder.
Returns the settings to the defaults.
Enter a filter name. You can enter up to 63 alphanumerical characters and symbols other
than #, %, &, +, \ (backslash), ' (apostrophe), ; (semicolon) and , (comma).
Select the IP version for IPsec.
 IPv4 — Select this to use IPsec under the IPv4 environment.
 IPv6 — Select this to use IPsec under the IPv6 environment.
The IP address of this equipment is set as the source address to which the filter is applied.
[My IP Address] is displayed in this box. This item cannot be changed.
Specify the destination address for the communication to which the filter is applied.
 Specific IP Address — Set a specific IP address. Enter the IP address in the address
input box.
 Subnet / Prefix — Set the destination with its IP address and subnet mask. Enter the IP
address and the prefix of the subnet mask directly in the address input box.
 FQDN — Sets FQDN for the destination. Enter FQDN in the address input box.
 Any IP Address — Set any IP address.
8 [Administration] Tab Page
Description
Description
[Setup] Item list 171