Spm Configuration File (Ams.cfg) Options - Lucent Technologies MERLIN LEGEND Release 6.0 System Programming And Maintenance Manual

MERLIN LEGEND Communications System Release 6.0
System Programming and Maintenance (SPM) 555-660-140
System Programming and Maintenance
Installing the SPM Software
The information you provide during the initialization process is written to the
SPM configuration file (ams.cfg). If you need to change this information at
some later time, you can do so in either of the following ways:
Use any of the options in Table 1 to change the information in
ams.cfg.
Edit the ams.cfg file. (If you are unsure about editing the file, you can
remove it. You are prompted to reinitialize the next time you invoke
SPM. The file is created at that time.)
NOTE:
The
DEBUG
default setting, or
Escape-to-Shell feature of SPM, activated by pressing
DEBUG on, you must edit the ams.cfg file; it is not part of the initialization
process. The DEBUG attribute is for use by qualified service personnel
only.
Table 1.

SPM Configuration File (ams.cfg) Options

Option
attribute is also specified in ams.cfg as
(on). This attribute is used to enable the
Use
Specifies COM1 as the serial communications port
used by SPM
Specifies COM2 as the serial communications port
used by SPM
Specifies modem speed of 1200 bps
Specifies modem speed of 2400 bps
Specifies color monitor
Specifies monochrome monitor
Specifies English as the PC language
Specifies French as the PC language
Specifies Spanish as the PC language
Issue 1
February 1998
Page 12
(off), the
+ . To turn