Lucent Technologies MERLIN LEGEND Release 6.0 System Programming And Maintenance Manual page 106

MERLIN LEGEND Communications System Release 6.0
System Programming and Maintenance (SPM) 555-660-140
System Programming and Maintenance
Surrogate Mode Programming
information on disk. This backup disk is then taken to the new installation site
and used with the Restore option to provide complete system programming for
a new communications system.
You do not "select" surrogate mode programming you enter it automatically
under the following conditions:
The PC is connected to the lower RS-232 port on a control unit (direct
local connection).
Only the processor and power modules are connected.
Once you enter surrogate mode programming, you must follow the sequence
of procedures shown below.
At the service location, perform the following:
At the installation site, perform a Restore.
While you are in surrogate mode, the Pass-Thru and Password options are not
available.
NOTE:
Surrogate mode is available only through the local programming port. You
cannot access surrogate features through the system programming
console.
1. System Erase
2. Program the Boards
3. System Programming
4. Backup
Issue 1
February 1998
Page 92