Lucent Technologies MERLIN LEGEND Release 6.0 System Programming And Maintenance Manual page 84

MERLIN LEGEND Communications System Release 6.0
System Programming and Maintenance (SPM) 555-660-140
System Programming and Maintenance
Upgrading the System
NOTE:
You must have a version later than SPM 4.15 to upgrade from Release
3.1 to Release 4.0.
MERLIN II Communications System programming cannot be upgraded to this
communications system. The new communications system must be completely
reprogrammed.
Before You Begin
Before you begin the upgrade to Release 6.0, you will need the items listed
below.
SPM Version 6.15 or later to back up and convert system
programming information and to restore system programming
information after the processor module with PCMCIA memory card
slot has been installed.
One or both of the following:
— Processor module with PCMCIA memory card slot (when
— A forced installation PCMCIA memory card with Release 6.0
DOS-formatted diskette
NOTE:
If SPM is already installed, the
you start SPM identifies the version on both the last line of the console
simulation window and in the upper left corner of the screen. If you are
working with Version 6.15,
screen and
simulation window.
converting from Release 2.1 or earlier).
system software (when converting from any release).
appears on the last line of the console
à Ã
screen that appears when
appears in the upper left-hand corner of the
Issue 1
February 1998
Page 70