Lucent Technologies MERLIN LEGEND Release 6.0 System Programming And Maintenance Manual page 22

MERLIN LEGEND Communications System Release 6.0
System Programming and Maintenance (SPM) 555-660-140
System Programming and Maintenance
Installing the SPM Software
Runs the DOS SETVER command to set the version table for
print.exe to 6.22. This is required to enable print.exe to run on
Windows 95.
Creates an spm.bat file in the directory c:\spm. The spm.bat file
contains the ams_path and print statements required to run SPM.
Unzips and copies the remaining files into the directory c:\spm.
Instructs you to refer to this document for details on using the PIF
Editor to configure an SPM PIF file to work with the spm.exe file.
Installation
With Windows 95 running on your PC, follow these steps to install SPM on the
PC's hard drive:
1. Insert a backup copy of SPM in any floppy disk drive (usually the
A drive).
2. Choose one of the following two methods to install SPM:
Method 1- Install DOS SPM with French, Spanish, or English
Language:
a.
b.
c.
NOTE:
Because English is the factory-set language,
JOTUBM  FOHMJTI
language argument (
Open a DOS Window from the Windows Explorer.
At the DOS prompt, switch to the drive with the backup copy of
SPM diskette (usually the A drive).
At the DOS prompt, type one of the commands shown below
and press
have the same result. If you do use the
JOTUBM 
, or
Issue 1
February 1998
Page 8
and
), you must type it