Lucent Technologies MERLIN LEGEND Release 6.0 System Programming And Maintenance Manual page 66

MERLIN LEGEND Communications System Release 6.0
System Programming and Maintenance (SPM) 555-660-140
System Programming and Maintenance
Using SPM
A Pass-Thru request to a locally-connected IS II/III system causes the modem
to fall back to 1200 bps if the speed is set to 2400 bps and the modem call to
the control unit is at 1200 bps. If necessary, the communications system
adjusts its speed to that of the local SPM PC.
Once the Pass-Thru connection is established, you can program in any of the
following IS II/III applications from your SPM PC:
AUDIX Voice Power™
Call Accounting System
Fax Attendant System (IS III only)
CONVERSANT Intro (IS III only)
NOTE:
You cannot program the SPM application on the IS II/III PC because the
remote call (from your SPM PC) uses the IS II/III PC's COM1 port;
therefore, the system programming jack cannot be used for system
programming. For the same reason, a user at the IS II/III PC end of the
connection cannot use SPM while your Pass-Thru is in effect. If use of
SPM is attempted, the user at the IS II/III end sees the following message:
To initiate Pass-Thru, establish a modem connection between the SPM PC and
the control unit.
If the IS II/III PC does not respond to the Pass-Thru request from the control
unit (for example, because the PC is turned off), you see the following
message:
If the connection between the control unit and the IS II/III PC fails, the
connection between the control unit and the SPM PC is dropped. You see the
following message:
Issue 1
February 1998
Page 52