Lucent Technologies MERLIN LEGEND Release 6.0 System Programming And Maintenance Manual page 24

MERLIN LEGEND Communications System Release 6.0
System Programming and Maintenance (SPM) 555-660-140
System Programming and Maintenance
Installing the SPM Software
6. Press any key to continue installation. When SPM installation is
complete the following message appears:
7. Press any key
— If you installed DOS SPM using Method 1 in Step 2, close the
— If you installed DOS SPM using Method 2 in Step 2, the DOS
8. If the print.exe file was copied to your PC in Step 5, you must
reboot your PC.
9. You should now configure a PIF file for SPM. Use the instructions
that follow
Configuring a PIF file for DOS SPM
Refer to the Windows 95 help topic on "PIF" for details on using the PIF editor
to implement an SPM PIF file to work with the spm.exe file.
SPM Note: The warning message seen above was produced by
the SETVER command. This command was used in the SPM
install program to set the proper version of PRINT.EXE
file in the DOS version table. Please note that in Windows
95, running SETVER always produces the warning message
seen above, even when the command is run properly.
*******************************************************
Press any Key to continue . . .
Installation of SPM for DOS on your Windows 95 hard drive
is now complete. For easy access to SPM from Windows 95,
configure an SPM.PIF file. See the SPM Manual for details.
Press any key to continue . . .
DOS Window by typing
. If the window does not close, then the Close on Exit
option for the DOS window is not set. In this case, close the
window by clicking on the upper right window icon (the box with
an x in it).
window closes automatically.
at the DOS prompt and pressing
Issue 1
February 1998
Page 10