Lucent Technologies MERLIN LEGEND Release 6.0 System Programming And Maintenance Manual page 37

MERLIN LEGEND Communications System Release 6.0
System Programming and Maintenance (SPM) 555-660-140
System Programming and Maintenance
Accessing SPM
— Place a call to the system on a Remote Access line, enter the
— Place a voice call to the system using the line to which the
Considerations
Review the following items before you begin the modem connection procedure.
Set the Programming Language
If you prefer to program in a language other than the current SPM language
setting, see "Language."
Modem Connections
You must make a data connection to a modem. The following modem dialing
commands are for Hayes and Hayes-compatible modems. These may not be
the commands your modem uses refer to the user guide that came with your
modem for specific information.
If the PC is in the same location as the control unit, type   .
If the PC is in a remote location and your system has activated the
Remote Access feature, type the following and press
— Without barrier codes type:
— With barrier codes type:
barrier code (if required), and dial the code for the internal
modem (   ).
modem is connected and ask the operator to transfer you to
the modem (by pressing Transfer, dialing   , then hanging up
the telephone). When you hear the modem answer tone,
switch to data mode.
; the remote access telephone number; and X  .
ATDT
For example: 6U9U ! $$$ !"#ÃX 
Issue 1
February 1998
Page 23
:
.