Viewing Drive Properties - Lenovo ThinkServer RD330 Software User's Manual
Megaraid sas software user guide
Hide thumbs
Also See for ThinkServer RD330:
- Safety information manual (288 pages) ,
- Benutzerhandbuch (212 pages) ,
- Guía del usuario (202 pages)
Table of Contents
Advertisement
MegaRAID SAS Software User Guide
4.8.3
Viewing Drive Properties
CAUTION: Before you run an initialization, back up any data on the virtual drive that
you want to save. All data on the virtual drive is lost when you initialize the drive.
Select CC to run a consistency check on this virtual drive. For more information, see
Section 4.12.1, Running a Consistency
virtual drives.)
Select AdvOpers to access screens to remove drives, migrate RAID levels (that is,
change the virtual drive configuration by adding a drive and changing the RAID
level), and use MegaRAID Recovery.
See
Section 4.12.8, Migrating the RAID Level of a Virtual Drive
adding a drive to a virtual drive or migrating its RAID level. See
MegaRAID Recovery
for the MegaRAID Recovery procedure.
Select Enable MegaRAID Recovery to use MegaRAID Recovery, also known as
Snapshot. Recovery offers a simplified way to recover data and provides automatic
protection for the boot volume. You can use the Recovery feature to take a snapshot
of a volume and to restore a volume or file.
See
Section 4.10, Using MegaRAID Recovery
Select Expand to increase the size of a virtual drive to occupy the remaining
capacity in the drive group. In addition, you can add drives to the virtual drive in
order to increase capacity.
See
Section 4.9, Expanding a Virtual Drive
virtual drive.
CAUTION: Before you change a virtual drive configuration, back up any data on the
virtual drive that you want to save.
The Physical Drive screen displays the properties of a selected drive and enables you to
perform operations on the drive. There are two ways to access the Physical Drive
screen:
On the main menu screen, click on a drive in the right panel under the heading
Physical Drives.
On the main menu screen, click on Physical Drives in the left panel to display the
Physical Drive screen. Then click on a drive in the right panel. Click on the
Properties button, and click Go. The properties for the selected drive displays.
Figure 86
shows the Physical Drive screen.
Chapter 4: WebBIOS Configuration Utility
Check. (This option is not available for RAID 0
for the MegaRAID Recovery procedure.
for the procedure you can use to expand a
|
Viewing and Changing Device Properties
for information about
Section 4.10, Using
Page 131
Advertisement
Table of Contents
