Lenovo ThinkServer RD330 Software User's Manual page 99

MegaRAID SAS Software User Guide
— Write Policy: Specify the write policy for this virtual drive:
WBack: In Writeback mode the controller sends a data transfer completion signal
to the host when the controller cache has received all of the data in a
transaction.
This setting is recommended in Standard mode.
WThru: In Writethrough mode the controller sends a data transfer completion
signal to the host when the drive subsystem has received all of the data in a
transaction.
This is the default.
Bad BBU: Select this mode if you want the controller to use Writeback mode but
the controller has no BBU or the BBU is bad. If you do not choose this option, the
controller firmware automatically switches to Writethrough mode if it detects a
bad or missing BBU.
CAUTION: We allow Writeback mode to be used with or without a battery. We
recommend that you use either a battery to protect the controller cache, or an
uninterruptible power supply (UPS) to protect the entire system. If you do not use a
battery or a UPS, and there is a power failure, you risk losing the data in the controller
cache.
— IO Policy: The IO Policy applies to reads on a specific virtual drive. It does not
affect the read ahead cache.
Direct: In Direct I/O mode, reads are not buffered in cache memory. Data is
transferred to the cache and the host concurrently. If the same data block is read
again, it comes from cache memory. This is the default.
Cached: In Cached I/O mode, all reads are buffered in cache memory.
— Drive Policy: Specify the drive cache policy:
Enable: Enable the drive cache.
Disable: Disable the drive cache. This drive policy is the default.
NoChange: Leave the current drive cache policy as is.
This is the default.
— Disable BGI: Specify the background initialization status:
No: Leave background initialization enabled. This means that a new
configuration can be initialized in the background while you use WebBIOS to do
other configuration tasks. This is the default.
Yes: Select Yes if you do not want to allow background initializations for
configurations on this controller.
— Select Size: Specify the size of the virtual drive in megabytes. Normally, this
would be the full size for RAID 50 shown in the Configuration Panel on the right.
You can specify a smaller size if you want to create other virtual drives on the
same drive group.
17. Click Accept to accept the changes to the virtual drive definition or click Reclaim to
undo the changess
18. Click Next after you finish defining the virtual drives.
The Configuration Preview screen appears, as shown in Figure 55.
Chapter 4: WebBIOS Configuration Utility
|
Creating a Storage Configuration
Page 99