Lenovo ThinkServer RD330 Software User's Manual page 129

MegaRAID SAS Software User Guide
Table 21: Controller Properties Menu Options (Continued)
Option
Patrol Read Rate Use this option to select the rate for patrol reads for drives connected to
the selected controller. The default is 30 percent. The patrol read rate is
the percentage of system resources dedicated to running a patrol read.
See
information about patrol read.
Cache Flush Interval Use this option to control the interval (in seconds) at which the
contents of the onboard data cache are flushed. The default is 4
seconds.
Spinup Drive Count Use this option to control the number of drives that spin up
simultaneously. The default is 2 drives.
Spinup Delay Use this option to control the interval (in seconds) between spinup of
drives connected to this controller. The delay prevents a drain on the
system's power supply that would occur if all drives spun up at the same
time.
The default is 12 seconds.
StopOnError Enable this option if you want the boot process to stop when the
controller BIOS encounters an error during boot-up. The default is
Disabled.
Spin Down Delay Time Use this option to control the interval (in seconds) between spindown
of drives connected to this controller. The delay prevents a drain on the
system's power supply that would occur if all drives spun down at the
same time.
The default is 30 minutes.
Stop CC on Error Enable this option if you want to stop a consistency check when the
controller BIOS encounters an error. The default is No.
Maintain PD Fail Enable this option to maintain the history of all drive failures. The
History default is Enabled.
Schedule CC Indicates whether the option to schedule the date and time for a
consistency check is supported.
Snapshot Use this option to create a snapshot of a volume. MegaRAID Recovery,
also known as Snapshot, offers a simplified way to recover data and
provides automatic protection for the boot volume. You can use the
Recovery feature to take a snapshot of a volume and to restore a
volume or file. Snapshot functionality allows you to capture data
changes to the volume, and, if data is deleted accidentally or
maliciously, restore the data from the view or roll back to a snapshot at
a previous point-in-time (PiT). MegaRAID Recovery supports up to eight
snapshots of PiTs for each volume.
Disk Activity Enable this property if you want to locate a particular disk. This disk can
be identified with a continuous blinking of green activity LED. This
works only if the disks are installed in a enclosure.
Manage JBOD Converting the multiple JBOD drives to unconfigured drive at single
selection.
If you make changes to the options on this screen, click Submit to register them. If you
change your mind, click Reset to return the options to their default values.
Chapter 4: WebBIOS Configuration Utility
Description
Section 5.9, Patrol Read-Related Controller Properties
|
Viewing and Changing Device Properties
for additional
Page 129