Appendix B: Megacli Error Messages; Error Messages And Descriptions - Lenovo ThinkServer RD330 Software User's Manual

MegaRAID SAS Software User Guide
Appendix B
MegaCLI Error Messages
This appendix lists the MegaCLI error messages.
B.1 Error Messages and
Descriptions
The MegaCLI Configuration Utility is a command line interface application you can use
to manage MegaRAID SAS RAID controllers. See
the MegaCLI utility and commands.
Each message that appears in the event log has an error level that indicates the severity
of the event, as shown in Table 136.
Table 136: Error Messages and Descriptions
Number
0x00 Command completed successfully
0x01 Invalid command
0x02 DCMD opcode is invalid
0x03 Input parameters are invalid
0x04 Invalid sequence number
0x05 Abort isn't possible for the requested command
0x06 Application 'host' code not found
0x07 Application already in use - try later
0x08 Application not initialized
0x09 Given array index is invalid
0x0a Unable to add missing drive to array, as row has no empty
slots
0x0b Some of the CFG resources conflict with each other or the
current config
0x0c Invalid device ID / select-timeout
0x0d Drive is too small for requested operation
0x0e Flash memory allocation failed
0x0f Flash download already in progress
0x10 Flash operation failed
0x11 Flash image was bad
0x12 Downloaded flash image is incomplete
0x13 Flash OPEN was not done
0x14 Flash sequence is not active
0x15 Flush command failed
0x16 Specified application doesn't have host-resident code

Appendix B: MegaCLI Error Messages

Chapter 5 for more information about
Event Text
|

Error Messages and Descriptions

Page 387