Background Initialization - Lenovo ThinkServer RD330 Software User's Manual

Megaraid sas software user guide
Hide thumbs Also See for ThinkServer RD330:
Table of Contents

Advertisement

|
Chapter 2: Introduction to RAID
Components and Features
2.4.6

Background Initialization

Page 24
Copyback is also initiated when the first Self-Monitoring Analysis and Reporting
Technology (SMART) error occurs on a drive that is part of a virtual drive. The
destination drive is a hot spare that qualifies as a rebuild drive. The drive with the
SMART error is marked as "failed" only after the successful completion of the copyback.
This avoids putting the drive group in degraded status.
NOTE: During a copyback operation, if the drive group involved in the copyback is
deleted because of a virtual drive deletion, the destination drive reverts to an
Unconfigured Good state or hot spare state.
Order of Precedence.
In the following scenarios, rebuild takes precedence over the copyback operation:
If a copyback operation is already taking place to a hot spare drive, and any virtual
drive on the controller degrades, the copyback operation aborts, and a rebuild
starts. The rebuild changes the virtual drive to the optimal state.
The rebuild operation takes precedence over the copyback operation when the
conditions exist to start both operations. For example:
— Where the hot spare is not configured (or unavailable) in the system.
— There are two drives (both members of virtual drives), with one drive exceeding
the SMART error threshold, and the other failed.
— If you add a hot spare (assume a global hot spare) during a copyback operation,
the copyback is aborted, and the rebuild operation starts on the hot spare.
Background initialization is a check for media errors on the drives when you create a
virtual drive. It is an automatic operation that starts five minutes after you create the
virtual drive. This check ensures that striped data segments are the same on all of the
drives in the drive group.
Background initialization is similar to a consistency check. The difference between the
two is that a background initialization is forced on new virtual drives and a consistency
check is not.
New RAID 5 virtual drives and new RAID 6 virtual drives require a minimum number of
drives for a background initialization to start. If there are fewer drives, the background
initialization does not start. The following number of drives are required:
— New RAID 5 virtual drives must have at least five drives for background
initialization to start.
— New RAID 6 virtual drives must have at least seven drives for background
initialization to start.
The default and recommended background initialization rate is 30 percent. Before you
change the rebuild rate, you must stop the background initialization or the rate change
will not affect the background initialization rate. After you stop background
initialization and change the rebuild rate, the rate change takes effect when you restart
background initialization.
MegaRAID SAS Software User Guide

Advertisement

Table of Contents
loading

Table of Contents