Flush Controller Cache; Set Controller Properties - Lenovo ThinkServer RD330 Software User's Manual

MegaRAID SAS Software User Guide
5.8.4

Flush Controller Cache

5.8.5

Set Controller Properties

Use the command in the following table to flush the controller cache on the selected
controller(s). This option sends the contents of cache memory to the virtual drive(s). If
the MegaRAID system must be powered down rapidly, you must flush the contents of
the cache memory to preserve data integrity.
Table 40: Cache Flush on Selected Controller
Convention
MegaCli –AdpCacheFlush -aN|-a0,1,2|-aALL
Description Flushes the controller cache on the selected controller(s).
This command sets the properties on the selected controller(s).
For example, for {RebuildRate -val}, you can enter a percentage between 0
percent and 100 percent as the value for the rebuild rate.
(The rebuild rate is the percentage of the compute cycles dedicated to rebuilding failed
drives.) At 0 percent, the rebuild is done only if the system is not doing anything else. At
100 percent, the rebuild has a higher priority than any other system activity.
NOTE: We recommend the default rebuild rate of 30 percent, and the default patrol
read rate of 30 percent.
Use the command in Table 41
controller(s).
Chapter 5: MegaRAID Command Tool
to display the list of properties you can set for the
|
Controller Property-Related Options
Page 183