Installing An Snmp Agent On Windows - Lenovo ThinkServer RD330 Software User's Manual
Megaraid sas software user guide
Hide thumbs
Also See for ThinkServer RD330:
- Safety information manual (288 pages) ,
- Benutzerhandbuch (212 pages) ,
- Guía del usuario (202 pages)
Table of Contents
Advertisement
Chapter 6: MegaRAID Storage Manager Overview and Installation
ing an SNMP Agent
6.7.3.6
Configuring SNMP Traps
6.7.3.7
Uninstalling the SNMP
Package
6.7.4
Installing an SNMP Agent on
Windows
6.7.4.1
Installing SNMP Agent
6.7.4.2
Installing SNMP Service
for Windows
Page 246
|
Installing and Configur-
To receive SNMP traps, perform the following steps:
1. Stop the SAS SNMP Agent by using the following command:
#/etc/init.d/lsi_mrdsnmpd stop
2. Edit the /etc/lsi_mrdsnmp/sas/sas_TrapDestination.conf file and add the
ipaddress as shown in the following excerpt:
#################################################
# Agent Service needs the IP addresses to sent trap
# The trap destination may be specified in this file
# or using snmpd.conf file. Following indicators can
# be set on "TrapDestInd" to instruct the agent to
# pick the IPs as the destination.
# 1 - IPs only from snmpd.conf
# 2 - IPs from this file only
# 3 - IPs from both the files
#################################################
TrapDestInd 2
#############Trap Destination IP##################
127.0.0.1
public
172.28.157.149 public
#################################################
3. Start the SAS SNMP Agent by entering the following command:
#/etc/init.d/lsi_mrdsnmpd start
The uninstall.sh script is located under the /etc/lsi_mrdsnmp/sas directory. Use
the following command to uninstall the package:
# cd /etc/lsi_mrdsnmp/sas
# ./uninstall.sh
This section explains how to install and configure SAS SNMP Agent for the Windows
operating system.
Perform the following steps to install SNMP Agent:
1. Run setup.exe from DISK1.
2. Use SNMP Manager to retrieve the SAS data (it is assumed that you have compiled
LSI-AdapterSAS.mib file already).
The LSI-AdapterSAS.mib file is available under %ProgramFiles%\LSI
Corporation\SNMPAgent\SAS directory.
3. Use a trap utility to get the traps.
NOTE: Before you install the Agent, make sure that SNMP Service is already installed in
the system.
If you do not have SNMP Service installed on your system, perform the following steps
to install SNMP Service for a Windows system:
MegaRAID SAS Software User Guide
Advertisement
Table of Contents
