Display Time And Date On Controller; Get Connector Mode; Set Connector Mode - Lenovo ThinkServer RD330 Software User's Manual

Chapter 5: MegaRAID Command Tool
5.8.10 Display Time and Date on
Controller
5.8.11

Get Connector Mode

5.8.12

Set Connector Mode

Page 186
|
Controller Property-Related Options
Use the command in the following table to display the time and date on the selected
controller(s).
Table 46: Display Time and Date on Controller
Convention
Description
Use the command in the following table to display which ports are enabled
(Internal/External, 0/1) on the MegaRAID SAS 8888ELP RAID controller.
NOTE: This command is reserved strictly for the SAS 8888ELP RAID controller at this
time. You must enable specific ports depending on how you intend to use the controller.
Table 47: Get Connector Mode
Convention
Description
Use the command in the following table to set (enable) the connectors for the
MegaRAID SAS 8888ELP RAID connectors that are listed in
Connector
NOTE: This command is reserved strictly for the SAS 8888ELP RAID controller at this
time. You must enable specific ports depending on how you intend to use the controller
Table 48: Set Connector Mode
Convention
Description
MegaCli –AdpGetTime -aN
Displays the time and date on the controller. This command uses a 24-hour
format. For example, 7 p.m. would display as 19:00:00.
MegaCli -AdpGetConnectorMode
-ConnectorN|-Connector0,1|-ConnectorAll
-aN|-a0,1,2|-aALL
Displays which ports are enabled (Internal/External, 0/1).
For example, if internal port 0 is active, internal ports 0-3 are active. If
external port 1 is active, external ports 4-7 are active.
Mode.
MegaCli -AdpSetConnectorMode
-Internal|-External|-Auto
-ConnectorN|-Connector0,1|-ConnectorAll
-aN|-a0,1,2|-aALL
Sets (enables) the connectors listed in the GetConnectorMode command.
For example, to enable internal ports 4-7 on controller 0, run the following
command:
MegaCli –AdpSetConnectorMode –Internal –Connector1
–a0
MegaRAID SAS Software User Guide
Section 5.8.11, Get