Drive-Related Options; Display Drive Information; Set The Drive State To Online; Set The Drive State To Offline - Lenovo ThinkServer RD330 Software User's Manual
Megaraid sas software user guide
Hide thumbs
Also See for ThinkServer RD330:
- Safety information manual (288 pages) ,
- Benutzerhandbuch (212 pages) ,
- Guía del usuario (202 pages)
Table of Contents
Advertisement
Chapter 5: MegaRAID Command Tool
5.15
Drive-Related Options
5.15.1
Display Drive Information
5.15.2
Set the Drive State to Online
5.15.3
Set the Drive State to Offline
Page 204
|
Drive-Related Options
You can use the commands in this section to select settings for the drives and perform
actions on them.
Use the command in the following table to display information about the drives on the
selected controller(s).
Table 86: Display Drive Information
Convention
Description
Use the command in the following table to set the state of a drive to Online.
In an online state, the drive is working normally and is a part of a configured virtual
drive.
Table 87: Set Drive State to Online
Convention
Description
Use the command in the following table to set the state of a drive to Offline.
In the offline state, the virtual drive is not available to the RAID controller.
Table 88: Set Drive State to Offline
Convention
Description
MegaCli –PDInfo -PhysDrv[E0:S0,E1:S1....]
-aN|-a0,1,2|-aALL|
Provides information about the drives connected to the enclosure and
controller slot. This includes information such as the enclosure number, slot
number, device ID, sequence number, drive type, capacity (if a drive), foreign
state, firmware state, and inquiry data.
For SAS devices, this includes additional information such as the SAS address
of the drive. For SAS expanders, this includes additional information such as
the number of devices connected to the expander.
-Physdrv[E0:S0,...]: Specifies the physical drive enclosure and the
slots for the drives to provide information about.
MegaCli –PDOnline -PhysDrv[E0:S0,E1:S1....]
-aN|-a0,1,2|-aALL
Changes the drive state to Online.
-Physdrv[E0:S0,...]: Specifies the physical drive enclosure and the
slots for the drives.
MegaCli –PDOffline -PhysDrv[E0:S0,E1:S1....]
-aN|-a0,1,2|-aALL
Changes the drive state to Offline.
-Physdrv[E0:S0,...]: Specifies the physical drive enclosure and the
slots for the drives.
MegaRAID SAS Software User Guide
Advertisement
Table of Contents
