Expanding A Virtual Drive - Lenovo ThinkServer RD330 Software User's Manual

Chapter 4: WebBIOS Configuration Utility
4.9

Expanding a Virtual Drive

Page 136
|
Expanding a Virtual Drive
— BBU Auto Learn Disabled: Firmware does not monitor or initiate a learning cycle.
You can schedule learning cycles manually.
— BBU Auto Learn Warn: Firmware warns about a pending learning cycle. You can
initiate a learning cycle manually. After the learning cycle is complete, firmware
resets the counter and warns you when the next learning cycle time is reached.
Perform the following steps to choose an auto learn mode:
a. Open the drop-down menu in the Auto Learn Mode field.
b. Select an auto learn mode.
c. Click Go to set the auto learn mode.
NOTE: When you replace the iBBU, the charge cycle counter is reset automatically.
You can increase the size of a virtual drive to occupy the remaining capacity in a drive
group. In addition, you can add drives to the virtual drive in order to increase capacity.
Follow these steps to expand a virtual drive.
1. Access the Virtual Drive screen by clicking a virtual drive icon in the right panel on
the WebBIOS CU main screen.
The Virtual Drive screen appears, as shown in Figure 90.
Figure 90:
2. Click the Expand radio button and then click Go.
The Expand Virtual Drive screen appears, as shown in Figure 91.
Virtual Drive Screen
MegaRAID SAS Software User Guide