Error Code Tables - Kyocera KM-1650 Operation Manual

Error Code Tables

When a communications error occurs, one of the following error codes will be printed out on the
corresponding Transmission Report or Reception Report as well as the Activity Report.
Note
If an error occurs during communication at a transmission speed of 33600 bps, the "U" in the error
codes noted below will change to an "E"
CODE
Busy
Stopped
U00300
U00420 -
U00462
U00600 -
U00690
U00700
U00800
U00810
U00900
U00910
U01000 -
U01092
U01100 -
U01199
U01400
U01500
U01600
U01700
U01720
U01721
U01800 -
U01820
U01821
.
CAUSE AND/OR PROCEDURE FOR CORRECTION
The line is busy or the other party does not answer after automatically redialling the
set number of times. Perform transmission or reception procedures again.
Transmission has been interrupted by pressing the Stop/Clear key.
Reception has been interrupted by pressing the Stop/Clear key.
During multiple communication (Polling Reception, etc.), this unit was unable to
transmit to all destinations due to a communications interruption.
The destination fax has run out of recording paper. Check with the destination
party.
Connection was made on a call initiated by the transmitting party, but the
transmission has been interrupted because the transmitting party does not
possess the necessary communication capabilities.
Communication was interrupted due to trouble with your unit. Perform transmission
or reception procedures again.
Communication was interrupted due to trouble with the other party's fax unit.
Check with the other party.
Unsuccessfully transmitted page(s) remain. Perform transmission procedures
again.
Unsuccessfully received page(s) remain. Perform reception procedures again.
A communication error occurred during transmission. Perform transmission
procedures again.
A communication error occurred during reception. Perform reception procedures
again.
A communication which uses the timer was scheduled, and a number was entered
using an abbreviated number or one-touch key, etc., but communication with that
party was impossible because that number was no longer registered when the
scheduled time arrived. Check your unit.
A communication error occurred during transmission at high transmission speed.
Perform transmission procedures again.
A communication error occurred during reception at high transmission speed.
Perform reception procedures again after having the transmitting party lower the
transmission speed.
A communication error occurred during transmission at high transmission speed.
Perform transmission procedures again.
A communication error occurred during transmission at high transmission speed.
The destination party's fax may not have the corresponding high speed reception
capabilities. If the destination party's fax number was dialled using an abbreviated
number or one-touch key, change the transmission speed registered for that
number to a lower setting and perform transmission procedures again.
A communication error occurred during reception at high transmission speed.
Perform reception procedures again after having the transmitting party lower the
transmission speed.
A communication error occurred during reception at high transmission speed. Your
unit may not have the corresponding high speed reception capabilities. Perform
reception procedures again after having the transmitting party lower the
transmission speed.
Reference Information
10-7