Load The Tone Curve; Tone Curve Management] Screen - Konica Minolta bizhub PRESS C6000 User Manual

8.4

Load the Tone Curve

8.4 Load the Tone Curve
In the image controller, there is the tone curve registered at factory shipping. You can also register the tone
curve which you adjusted on [Tone Curve Adjustment] screen. Color Centro can load these tone curves and
also make adjustment.
The tone curve registered at factory shipping in the image controller cannot be adjusted and overwritten.
When you want to adjust the tone curve registered at factory shipping, load the duplication of it which was
made beforehand and adjust the duplication. For detailed information on how to duplicate, refer to page 8-20.
This section describes how to load the tone curve.
You can select the tone curve to load on [Tone Curve Management] screen.
8.4.1

[Tone Curve Management] screen

[Tone Curve Management] screen is composed as follows;
Item
(tree view)
(list)
[Copy]
[Delete]
[Reload]
[Change Table Information]
[Export]/[Register]
[Open]
[Cancel]
[Help]
Status bar
IC-601
Description
Displays the places where the tone curve are saved ([Controller], [Lo-
cal], [My Documents] and [Network]) in the tree format.
According to the selection of the tree view, displays the saved tone
curves.
Makes a duplication of the selected tone curve from the list within
[Controller], when [Controller] is selected on the tree view.
Deletes the tone curve selected from the list.
Updates the information of the list.
Changes the table information (Saved Name, Memo) of the tone
curve which is selected from the list.
Exports the selected tone curve on the list to [Local]/[My Docu-
ments]/[Network], when [Controller] is selected on the tree view.
Registers the tone curve selected on the list to [Controller], when a
folder other than [Controller] is selected on the tree view.
Loads the selected tone curve on the list to [Tone Curve Adjustment]
screen.
Close this screen and exits this function.
Displays the Help of this screen.
Displays the IP address and the port number of the image controller
connected currently.
8
8-9