13.2
Create the new Color Configuration
13.2.4
Set the Color Conversion Option
Specify the Color Conversion setting to use as default for the Color Configuration you create.
1
Click [Color Conversion Option Settings] - [Setting].
[Color Conversion Settings] appears.
2
Select the setting of Pure Black from [Use Pure Black].
3
Check [Use Gray Replacement] when you use Gray Replacement.
4
Check [Use Black Overprint] when you use Black Overprint.
5
Select the setting of Composite Overprint from [Use Composite Overprint].
6
Check [Use Spot Color] when you use Spot Color.
7
Check [Use Alternative Color Conversion] when you use Alternative Color Conversion.
8
Check [Use RGB Simulation] when you use RGB Simulation.
9
Check [Use Tone Curve Adjustment] and specify the torn curve when you use Tone Curve Adjustment.
10
If necessary, enter the description to [Memo].
11
Click [OK] and return to [Color Configuration Management] screen.
% Go to the step described on page 13-10.
13.2.5
Register the Color Configuration
This section describes how to register the settings to the image controller.
1
Click [Register] on [Color Configuration Management] screen.
% When there is the Color Configuration with the same name, it is registered as another name auto-
matically. In this case, the confirmation message appears.
IC-601
13
13-10