13.7
Improve the Accuracy of the Profile Set
13.7.2
Set the Profile Set Name and the Destination
1
Specify the name of Profile Set you edit in [Profile Set Name] of [Name Settings] screen.
% When you save the Profile Set with another name or to another place, enter the profile name and go
to Step 2.
% When you overwrite the Profile Set in which some settings are edited, go to Step 4.
% You cannot save the Profile Set of the same name with those registered at factory shipping in the
image controller.
% You cannot use "DEVICE" (not only the capital letter but also the small letter) for the Profile Set name
when you save the profile to the image controller.
2
Click [Browse].
[Select Destination Folder] screen appears.
3
Select the destination folder for saving the Profile Set you edit and click [OK].
The destination folder and file name are displayed on [Destination Folder] and [File Name] of [Name Set-
tings] screen.
4
Click [Next].
The Measurement Feedback screen appears.
% When there is a Profile Set with the same name, the [Confirmation : Overwrite] screen appears. To
save with another name, click [Cancel]. To overwrite, click [OK].
% Go to the step described on page 13-35.
IC-601
13
13-34